Asbestos in houses built before 2000: where it hides
Asbestos is a quiet part of the history of New Zealand building. It was cheap, fireproof and durable, and for some decades it went into almost every part of an ordinary house. Most of it is harmless while left alone and in good condition. The trouble starts when an owner with a hammer, a drill or a sander meets it unprepared. Renovating an older villa or bungalow is exactly the sort of work that does so.
This article summarises WorkSafe's guidance for homeowners and the regulations behind the removal rules. It is general information, and anyone planning work on a suspect material should get it tested first.
Which houses, and which years
WorkSafe's homeowner guidance says that a home built before 1 January 2000 may contain some asbestos materials, and that the risk is lower for homes built after that date. Consumer Protection's guide to building red flags is more specific about the history: asbestos, it says, was used widely from the mid-1940s until the mid-1980s, and may be found on ceilings, roofs, under lino and in fences. Both statements point the same way for the villa-and-bungalow era: houses of that age may well have had asbestos products added or installed during later renovations, even if the original 1900s construction was timber and iron.
Where it hides
WorkSafe's quick guide, Asbestos in the home (a copy hosted by South Taranaki District Council), lists the places it has been found. In an older Auckland house the likeliest are:
- Wet-area linings and cement sheeting. Asbestos cement (Fibrolite is the example given) was commonly used in kitchens, bathrooms, toilets and laundries, and as backing for wall tiles, bath panels and splashbacks.
- Textured ceilings and patching compounds. Ceilings finished with products such as Glamatex or Whisper, and textured paints, were sometimes made with asbestos.
- Flooring. Vinyl floor tiles and their adhesive, the backing of sheet vinyl and linoleum, some carpet underlays and some older poured floors.
- Heat-related insulation. Around heaters, fireplaces and stoves, in roof cavities and around hot water pipes, as well as flues.
- Roofing and the roof edge. Roof sheeting and ridge capping, gutters, downpipes, gables and eaves linings.
- Cladding. Some wall cladding, including imitation brick.
- Outbuildings. Fences, carports, garages, outhouses and garden sheds.
- Switchboards. Older electrical switchboards may contain it as an insulating material.
BRANZ adds a note relevant to the old interior linings of timber houses: when you strip wall linings in a villa, old cement-based sheet linings are sometimes present, and they often contain asbestos. Its advice is to follow WorkSafe's guidelines on testing, removal and working with asbestos, and to use trained and licensed professionals. That is in BRANZ's renovation series.
You cannot tell by looking
WorkSafe is blunt on this. It is very difficult to tell materials containing asbestos from those that do not: cement containing asbestos can look identical to cement without it. The only way to confirm is to test a sample, and sampling should be done only by a reputable contractor. If you are not sure whether something contains asbestos, treat it as if it does.
Friable and non-friable
WorkSafe distinguishes two kinds by condition.
- Friable asbestos is flaky or powdery and can be crumbled with little pressure, so it can easily release fibres. It is often called Class A.
- Non-friable asbestos has the fibres bonded into something like cement and is less likely to release them unless disturbed or deteriorating. It is often called Class B.
Fibres released into the air are too small to see, and WorkSafe's guide says that even a single exposure, especially at high concentration, can cause serious health problems later in life. Bonded material in good condition and left undisturbed generally does not release fibres, which is why the usual advice is not to disturb it. Sanding, drilling, cutting and water-blasting are the activities that do disturb it.
What the removal rules say
The Health and Safety at Work (Asbestos) Regulations 2016 set the licensing thresholds, and you can read them on the NZ Legislation site. In summary:
- Removing friable asbestos requires a Class A asbestos removal licence, and contravening the rule is an offence carrying a fine of up to $10,000 for an individual and $50,000 for any other person.
- Removing more than 10 square metres of non-friable asbestos, counted cumulatively over the whole removal project for the site, requires at least a Class B licence.
- Removing 10 square metres or less of non-friable asbestos does not require a licensed removalist, but where a business commissions the work, it must be done by a competent person trained as the regulations require.
WorkSafe's removal guidelines describe different classes of removal with different requirements depending on how much material is involved and how friable it is, and note that the removal of asbestos is covered by the 2016 asbestos regulations, the general risk and workplace management regulations and the Health and Safety at Work Act 2015. Those are set out on WorkSafe's page on asbestos removal.
For homeowners, there is a wrinkle. The quick guide explains that your home becomes a workplace for the duration of any work you pay someone to do, and that you then have duties as an "other person at the workplace": take reasonable care for your own health and safety, avoid putting others at risk, and follow reasonable instructions from the business doing the work. A residential landlord has stronger duties, to identify the asbestos and prepare an asbestos management plan for work with a risk of exposure.
The people involved
When asbestos work is commissioned, WorkSafe describes three kinds of contractor:
- Surveyors inspect, sample and report.
- Removalists assess the job from the surveyor's report, prepare an asbestos removal control plan, tell your neighbours, follow strict procedures and dispose of the waste.
- Assessors check that the work has been completed to standard, and should come from a different business to the removalist. They review the removal control plan, inspect the area, take air samples and confirm in writing that the area is safe to re-enter.
WorkSafe recommends checking a contractor's experience, qualifications, licensing, references and insurance, and it says you can verify removalist and assessor licences on its licence register.
If you find it, or disturb it
- Do not disturb it. Tell the people you live with, and your landlord if you rent. Keep children and pets away.
- Call a reputable asbestos contractor, or your local public health service, for advice.
- If you accidentally disturb it, stop, keep others out, close doors and windows, wipe yourself down with damp rags and do not use a brush, remove the top layer of clothes without shaking them, double-bag everything, and contact a contractor before going back in.
- Doing the work yourself is a last resort. WorkSafe strongly recommends getting advice from a reputable contractor before removing or working on any asbestos, and calls attempting it without specialist training extremely dangerous. If you have no option, it advises following safe work practices, taking waste to an authorised disposal site after talking to your council, and never burning asbestos or putting it in normal council bins.