Repainting an Auckland character home
Painting a villa is a bit like re-hanging a portrait: the house will tolerate a good deal, but the wrong frame shows. A repaint is both the most visible job an owner will do and the main defence the weatherboards have against the weather. It pays to get the colours, the paperwork and the preparation right before the first brush goes on.
What colours did these houses wear?
Te Ara's history of New Zealand housing is a useful guide to the palette. The earliest cottages were often left unpainted, but where they were painted the colours were stone-like: creams, fawns and greys, with corrugated-iron roofs painted in red oxide. Villas carried on the same body colours, with darker tones, particularly reds and greens, for the trim.
Bungalows brought a slightly different look. According to Te Ara, they were often painted white or beige with dark green or brown trim, and the style's features included low-pitched gabled or hipped roofs, bow windows, casement and fanlight windows and carrara plaster ceilings. The moderne houses that followed in the 1930s, Te Ara adds, had flat rooflines and stucco exteriors painted in white and pastel hues.
None of this is a rulebook. It does give you a defensible starting point: a restrained body colour, a contrast on the joinery, verandah posts and fascias, and a roof that suits the era. Dark colours on a sun-facing wall are worth thinking about, because BRANZ lists fading and chalking of the paint finish, especially with dark colours, among the common appearance problems of timber weatherboards.
Special Character Areas
Many of Auckland's older streets sit inside a Special Character Area under the Auckland Unitary Plan. Chapter D18 of the Unitary Plan explains that the overlay is meant to retain the special character values of specific residential and business areas, and that standards manage the use, development and demolition of buildings in them. It covers three kinds of area: residential, business, and general areas that mix the two.
What does that mean for a painter? In the activity table, restoration and repair to a building on all sites in the residential overlay (and in general-overlay areas zoned residential) is listed as a permitted activity. For business areas, external redecoration and repair of character-defining and character-supporting buildings is likewise permitted. The chapter also uses colour as an assessment matter for alterations and additions, asking whether the colour scheme is compatible with the age and detailing of the building.
Two cautions apply. The chapter published on the Unitary Plan website is marked as the July 2026 version, with new text still to be inserted through a plan change, so the wording may have moved by the time you read this. And the rules above are the plan's headline provisions, not advice on a particular property: whether a given job counts as redecoration, or whether the house is subject to a heritage overlay with its own rules, is a question for Auckland Council. Check the property in the council's maps before assuming anything, especially if you plan to change colour dramatically or to alter joinery and details along with it.
Preparing old timber
Preparation takes longer than painting, and it decides how long the job lasts. BRANZ's guide to horizontal timber weatherboards has the clearest sequence.
- Wash first. Wash down with water, or a chemical wash if needed, to remove dirt and mildew. Avoid a high-pressure waterblaster, which can erode the paint and drive water between the laps and behind facings.
- Look hard at the boards. Rot is generally visible but can be confirmed by prodding the timber with a screwdriver: if it goes in easily, the timber is rotten. Cut out rotted sections and seal and prime the cut ends. Small splits can be filled with flexible exterior filler, while a split that lets water into the wall cavity means the board should be replaced.
- Deal with the paint. If paint is flaking or peeling but the timber is sound, scrape and sand it, wash, and prime all exposed timber before painting. If the paintwork is in poor condition overall, the best solution may be to strip it back to bare timber with a chemical stripper or hot air gun before priming and repainting.
- Fix the fixings. Punch proud nails in or replace them with stainless steel or galvanised fixings, and treat rust at corroded nail heads before priming.
Replacement boards are an issue of their own. BRANZ notes that original boards on older houses are imperial rather than metric and vary in profile, so matching the existing profile takes some hunting but is essential. Owners who would rather hand over painting character homes to a specialist should expect the preparation steps above to take up most of the job.
Lead and old paint
Before 1970, most houses were painted with lead-based paint, BRANZ points out, and you cannot identify it by looking at it; a lead test kit will tell you. When working on the exterior, close windows and doors, collect debris on a groundsheet, seal it in heavy-duty plastic bags and dispose of it according to local council requirements. Anyone preparing a pre-1970 house should read the BRANZ guidance on removing lead-based paint before they start scraping.
Layers of old paint
An old house may carry a century of coats, and there comes a point where more paint does not help. Purdue University's extension service explains that cross-grain cracking, where cracks run across the grain in the direction the paint was brushed, is caused by excessively thick paint build-up and is common on older homes repainted many times. Once it happens, it says, the only fix is to remove the old paint completely. A house showing that pattern is a stripping job rather than a quick overpaint.
Choosing who does the work
A character house is likely to need board replacement, filling and careful priming as well as painting, so many owners look for a painter with experience of old timber. The preparation list above doubles as a checklist when comparing quotes. Whoever you choose, ask how they will handle lead-based paint in a pre-1970 house and which primer and topcoat they propose for bare timber.
Timing is practical rather than fashionable. BRANZ says that maintaining weatherboards means washing them every six months in coastal conditions and annually further inland, so a good repaint is the start of a cycle, not the end of one. Eggshell & Co is one local option for owners who want to ask a painting team about heritage and character work.
Sources
- Te Ara: Housing, Style and form
- Auckland Council: Auckland Unitary Plan, D18 Special Character Areas Overlay, Residential and Business
- BRANZ: Horizontal timber weatherboards
- Purdue University Extension: Causes of exterior paint failure on wood (NCR-133)