The Weatherboard Journal

Villas, bungalows and the timber houses of Auckland

Damp subfloors in West Auckland's bush suburbs

20 November 2026

West Auckland's older houses sit in a landscape that the city has largely grown around rather than cleared: bush gullies, tall trees and shaded sections. It is pleasant above the floor. Beneath it, the same setting can leave the timber of a villa or bungalow in permanent half-light, and that is where the damp problems start.

What a damp subfloor does to a house

BRANZ's article on subfloor ventilation says that surveys of the condition of New Zealand's housing have regularly found that many homes with suspended timber floors have much less subfloor ventilation than the recommended levels, and that around 1.2 million existing homes have a suspended timber floor. It lists what a lack of ventilation can cause:

Not all of this is hidden. A musty smell in a hall, or condensation that returns on the same window each morning, can be a prompt to go and look under the house.

Two sources of moisture

The moisture comes from two directions. The first is ground moisture: water evaporating from bare earth under the house into the enclosed space. The second is water that arrives from elsewhere, such as a leaking pipe or drain, or rain running under the house from a poorly drained section.

BRANZ's advice on checking a subfloor addresses both. It suggests taking some dirt from under the house and rubbing it firmly onto your hand: if it stains like mud, there is probably too much moisture. It then recommends clearing the subfloor of obstructions like stored timber or rubbish, uncovering any vents that may have been blocked by garden soil or plantings (or by owners trying to keep pests out), making sure water after rain does not flow under the house by checking guttering, downpipes, plumbing and drains, and checking the clearance of wall claddings above the adjacent ground.

In a bush-edge section, plantings against the foundation walls are an easy way to block vents without noticing. Fallen leaves and soil can build against the perimeter, and BRANZ notes that cladding clearance above ground can also contribute to lack of ventilation and dampness.

How much ventilation is enough

NZS 3604:2011, the standard for timber-framed buildings, requires ventilation openings of not less than 3,500 mm² per square metre of floor area, spread evenly around the foundation perimeter. BRANZ says that figure applies to new construction but is a good target for anyone fixing the subfloor ventilation of an existing house. Ventilation should sit as close as possible to the underside of the timber floor structure and be spread around the building to allow cross ventilation.

The measurement that counts is the net open area of a vent: the actual free area through which air can pass, excluding the area taken up by vermin proofing, framing and decorative coatings. Two vents of the same overall size can differ in net open area, and a vent partly blocked by mesh or a coat of paint ventilates less than it looks. That is worth remembering when vents are screened against rodents, since the screening takes up some of the opening.

Where the ground stays wet even after ventilation is improved, or where more ventilation is hard to achieve, BRANZ says the ground under the building should be covered with polythene sheeting. It describes laying the sheets lapped by 150 mm, cut neatly around the piles and butted against the perimeter wall, with rocks or bricks to hold them down. A separate BRANZ renovation article suggests taping the polythene around each pile and says the building then reaches a new equilibrium of lower moisture content, usually after about a year.

Why damp timber attracts borer

The link between moisture and borer is one of the better-documented ones in the field. Consumer NZ says that borer attacks untreated and damp timber, that it is often found on the south side of buildings and in floor timbers because those areas are prone to damp, and that preventing the area under the floor from becoming damp is the key step.

Scion's fact sheet on the native two-toothed longhorn goes further. It says that when egg-laying occurs on timber already in a building, it is generally confined to damp, poorly ventilated locations, hence the predominance of infestations beneath floors, and that untreated rimu used for subflooring, bearers, joists and jack studs in such places is often severely damaged. The same sheet says that the beetle's larval development can last from two to eleven years depending on moisture, temperature and the nutritional value of the host, and that improving subfloor ventilation may sometimes reduce the risk of reinfestation.

Consumer NZ also observes that the two-toothed longhorn attacks living trees, so it can be more common in bush-clad areas. That is a point worth bearing in mind for houses that back onto bush: the beetles have a source close by, and a damp subfloor gives them a place to lay.

For owners weighing up subfloor borer treatment as a next step, the order of work matters. Treatment will only help if the moisture is dealt with at the same time, since Consumer NZ stresses that treatment must outlast the borer's life cycle and that the best prevention is a dry, ventilated subfloor.

A routine for bush-edge houses

BRANZ recommends that a check of the subfloor space is undertaken annually as part of normal house maintenance. A simple routine would be:

  1. Look at the vents from the outside: clear of soil, leaves and plants, and not painted shut.
  2. Crawl under, or send someone with a torch, to look for pooled water, damp soil, mould or fungus on timber, and drips from pipes.
  3. Check drainage after heavy rain: gutters, downpipes and the direction water takes on the section.
  4. Consider ground cover if the soil is still damp after drainage and vents are sorted.
  5. Look at the timber for exit holes and fresh dust, and note them for a specialist.

If borer activity is found, a specialist assessment tells you how far it extends. Pest Control West Auckland is a local business that treats subfloor borer, and it is sensible to ask any contractor how they will address the moisture that let the beetles in.

Sources

Also in the journal