Gaps, vents and old timber houses: keeping rats and mice out
An old timber house is, from a rodent's point of view, a collection of tunnels with a roof on. Hollow walls, a ventilated subfloor, a roof space with a warm layer of insulation, and a century of small gaps where pipes, wires and boards meet. Keeping rats and mice out of such a building is less a matter of one big repair than of closing many small openings, and doing it without blocking the airflow the timber needs.
Which rodents are involved
Consumer NZ counts one type of mouse, the house mouse, and three types of rat in New Zealand: the Norwegian or sewer rat (the most common, according to its list), the ship rat and the rare kiore. Predator Free NZ, however, says the most common rat in Aotearoa is the ship rat, so the sources differ on which is more common and it probably varies from place to place.
What matters for a house is how they behave. Consumer NZ says rats and mice need only a very small hole to get in, can climb vertical surfaces, can gnaw through walls and can squeeze through gaps around windows and doors. It adds that the ship rat likes to nest in insulation, and that trees overhanging the eaves can give rats a way into the ceiling space. Predator Free NZ's writer describes the ship rat as shy and more likely to be heard than seen, with scuttling noises above the ceiling often the only sign.
Why it matters to the building
Rodents do real damage to an old house. Predator Free NZ says they chew through wiring, timber, insulation and pipes. Chewed insulation can be pulled down so that it no longer warms the home, damaged wires create fire risk and power outages, and gnawed water pipes can cause floods in roofs, walls, floors and kitchens. The same article quotes the Insurance Council of New Zealand as saying that rodent and vermin damage is typically excluded under most standard household policies, so prevention is cheaper than repair.
Consumer NZ also notes that mice can chew through wiring, causing an electrocution hazard, and that rats are unsanitary.
Where they get in
Neither source lists every possible entry point, but the places they and BRANZ mention are the ones to check first.
- Gaps around windows and doors. Consumer NZ says doors and windows should fit tightly, since rodents can squeeze through gaps around them.
- Holes around pipes. Consumer NZ recommends sealing holes around pipes with metal or cement.
- Basements and subfloor openings. Consumer NZ suggests putting fine wire mesh across holes into basements. In a villa the equivalent is the line of foundation vents and any gaps in the perimeter.
- Eaves and roof edges. Overhanging branches can bridge the gap, according to the same guide, and ship rats are noted for nesting in insulation in the ceiling.
- The routes they already use. Predator Free NZ's recommended approach is to identify three things in any rodent problem: access points, nests and sebum trails. A sebum trail, the greasy mark of dirt and oil from a rodent's fur, looks like Marmite smeared on a rafter or pipe, and following it leads back to the opening being used. Owners who would rather not do that crawling themselves can read about rodent-proofing as a service before deciding.
Vents: a difficult balance
The vents in the foundation wall of a villa are doing two jobs, and they sit uneasily together. BRANZ's article on subfloor ventilation says that ventilation openings should be not less than 3,500 mm² per square metre of floor area, spread around the foundation perimeter, and that the useful figure is the net open area, which excludes the area taken up by vermin proofing, framing and any decorative coatings. In other words, mesh over a vent is expected, but it reduces the opening.
BRANZ also notes that vents are sometimes blocked by owners trying to keep pests out. A blocked vent can cause a bigger problem than the one it solves. The same article lists fungal growth, timber decay, borer attack, rising damp and sagging joists among the consequences of poor subfloor ventilation. The better approach is to leave vents open and fit them with a durable mesh, then check that the mesh is intact and not clogged with leaves or soil.
A practical sequence
A reasonable order of work for an owner:
- Look for evidence first. Droppings, gnawed material, grease trails and noises in the ceiling tell you where they are, and which entry points they use.
- Fix the obvious gaps. Seal pipe penetrations with metal or cement, make sure external doors and windows close properly, and repair damaged vent screens.
- Cut off the bridges. Trim branches that touch the roof or overhang the eaves.
- Tidy the places they like to nest. Consumer NZ lists old newspapers, cupboards, spare rooms, insulation and basements indoors, and rubbish piles, old building materials and overgrown gardens outside.
- Then deal with the animals. Consumer NZ suggests baits and traps once access has been dealt with, with bait stations protected so that children and pets cannot reach them.
Predator Free NZ's advice on trapping is to place the traps unset, with lure, on sebum trails for seven days so that rodents get used to them, and to house any trap in a tunnel if children and pets can get to it.
When to get help
Rodent-proofing an old house can mean working in roof spaces and under floors, and it needs a good torch, protective gear and patience. Gloves and knee pads are the minimum, Predator Free NZ suggests. If entry points are hard to find or inaccessible, a professional assessment may be worthwhile, since proofing is as much about finding every opening as about closing the obvious ones.
Pest Control West Auckland is one local business that offers this work. A proofing job is only as good as its weakest point, which makes it worth asking any contractor how they plan to deal with vents, eaves and pipe penetrations, and how they will keep the subfloor ventilated.
Sources
- Consumer NZ: Borer and other pests
- Predator Free NZ Trust: True cost: predators can damage your home and your wallet
- BRANZ: Subfloor ventilation