The Weatherboard Journal

Villas, bungalows and the timber houses of Auckland

Scrim, sarking and the old interior linings of Auckland houses

20 November 2026

Knock on the wall of an older New Zealand house and the sound can tell a story, as we shall see. The answer matters, because the interior lining of an older house is not a modern, uniform thing but a sequence of fashions, each with its own habits and each with its own hazards when it comes to renovation.

The early arrangement: boards and scrim

In the nineteenth-century houses that make up so much of Auckland's inner suburbs, interior walls were commonly lined in wide, rough-sawn boards fixed to the studs. Te Ara's account of early houses says that these boards, known as deal, were attached to the inside walls and covered with a form of woven jute called scrim, over which wallpaper could be hung. In utility rooms, and often on ceilings, plain thin boards with their edges chamfered into V-joints covered large areas, while tongue-and-groove boards gave a sealed surface that could be painted or varnished. This is described in Te Ara's Building materials story.

The arrangement has a name: scrim and sarking. Wikipedia's summary of the technique, which is consistent with Te Ara, describes sarking as the boards nailed to the framing and scrim as the loose-weave cloth stapled or tacked over them, with the scrim in New Zealand usually jute or hessian and the sarking often native rimu. It lets you paper straight on to the wall.

You can recognise it by sound and by sight. Knocking produces the sound of wood, and wallpaper laid over it has an uneven finish; where the scrim has come away from the boards, the paper may appear to float loose from the wall.

Plaster and lath, for the better houses

Te Ara says that in more expensive houses and institutional buildings plaster walls were preferred. Until the early 1900s plaster was applied over timber laths, narrow thin wooden strips fixed to the frame, and in some government buildings metal laths with a punched surface to key the plaster replaced them in the early 1900s. So a villa in a good street may have plaster in its best rooms and sarking elsewhere, a mix that can confuse an owner opening up one wall after another.

Enter plasterboard

The arrival of plasterboard is dated by Te Ara: New Zealand Wallboards began producing it in 1927 in Mt Eden, Auckland, and Winstone bought the company in 1930. This was sold as Gibraltar board, and Te Ara says internal wall linings began changing from scrim on deal to plasterboard. Te Ara's timber page gives the details.

BRANZ warns that the old sheets used from the 1930s onward are not the equivalent of modern internal sheet linings, and that sometimes a house has modern plasterboard fixed over the original linings, which shows up as a wall surface sitting proud of the top edge of the skirting.

What BRANZ says about renovating these walls

BRANZ's Getting down to it gives direct advice for anyone refurbishing:

Ceiling roses and original cornices, it adds, are treasures to be preserved: they can be removed carefully and reinstated once the new linings are in.

Consent and character

Schedule 1 of the Building Act 2004 exempts building work on the internal linings or finishes of any wall, ceiling or floor of an existing dwelling, so re-lining does not in itself need building consent. The exemption does not remove the duty to meet the building code, and where new linings are expected to do bracing or fire-resisting work, it is worth asking the council how they see it. Insulating an external wall, by contrast, is a separate matter: the schedule's insulation exemption excludes external walls.

If the house is in an Auckland Special Character Area, note that the overlay's residential rules are framed around external alterations and additions, demolition and new buildings, rather than interior work. Even so, read the character statement for your area before you start, and ask the council if the work will touch the outside of the house.

Practical order of work

  1. Test any old sheet lining for asbestos before touching it.
  2. Switch off power and have wiring checked once the lining is removed.
  3. Remove scrim and wallpaper, then the sarking, bagging the waste.
  4. Renew building wrap, add insulation and any bracing.
  5. Re-line, reinstating ceiling roses and cornices where possible.

A wall of scrim and sarking is a charming piece of history on the day you buy the house, and a reasonable project on the day you decide to renovate it. Knowing what each layer is turns it into a sequence of steps rather than a surprise.

Sources

Also in the journal